Key points for managing cage-reared chickens:
I. Preparations before breeder chicks arrive
1, Preheat the area in advance to reach the required temperature, generally 26~28 degrees Celsius. After the chicks arrive, raise it to 32~35 degrees Celsius. If using a warm-air heater, do not blow hot air directly onto the chicks. Increase humidity to 65%~75% by sprinkling water on the floor or using other methods such as misting.
2. Before the chicks arrive, prepare cooled boiled water, starter feed, vitamins, electrolytes and multivitamins, glucose, etc. Put cooled boiled water containing 3% glucose and vitamins in the cage half an hour in advance.
3. Adjust the partition in each cage. If the water line and drinkers are used at the same time, adjust the water line to a height the chicks can reach for water. If it is not being used, raise the water line so the chicks cannot reach the nipples, then lower it for the chickens to use on day 7. It is best to cover the cage floor with a layer of plastic mesh with small holes to prevent leg injuries in the chicks. If plastic mesh is unavailable, a layer of newspaper may be used until it is removed on days 3–4. If paper is used, do not place the drinkers on it, to prevent water from spilling onto the paper and wetting the chicks’ feathers, which could make them cold.
4. Calculate the number of chickens per cage: the density is generally 1–7 days, 25–30 chickens per square meter.
II. After the chicks arrive
1, unload the vehicle as soon as possible after the chicks arrive, doing so in an orderly manner to avoid mistakes made in the rush. Place the boxes containing the chicks in the aisle, open the lids, and put the calculated number of chicks into the cages. Make sure the chicks get water as soon as possible, then remove the cardboard boxes from the poultry house.
2, because the cockerels are vent-sexed in the hatchery, and procedures such as comb trimming, toe clipping, immunization, and transportation leave them particularly weak, raise them in the upper cages, where the light is brighter and the temperature is higher, and care for them attentively.
3, if the chicks can get out of the cages, cut the chick boxes into strips and use them to block the cage doors.
4, Temperature: In cage brooding, the temperature in the upper cages can differ from that in the bottom cages by 3–4 degrees Celsius. Therefore, it is best to place the chicks in the top tier for brooding, then move them down to lower tiers in sequence according to stocking density. The temperature is generally 32–35 degrees Celsius.
5, lighting: Since most brooding cages are vertically stacked in 3–4 tiers, arrange the bulbs at alternating heights. The brighter the lighting, the better. Provide lighting for 1–3 hours per day for 24 days, then reduce the lighting by 1–2 hours each day until natural lighting is reached.
Key points for managing floor-raised chickens:
I. Preparations before the breeder chicks arrive
1, preheat in advance to reach the required temperature, generally 26–28 degrees Celsius. After the chicks arrive, raise it to 32–33 degrees Celsius. Increase humidity to 65%–75% by sprinkling water on the floor or using methods such as spraying.
2、Divide the area into several pens according to the number of chickens, preparing 1~2 extra pens beyond the actual requirement so weaker chicks can be housed. Spread approximately 10 centimeters of wood shavings or rice hulls on the floor of the pens, then distribute drinkers and feed trays according to the number of chickens. Place a brick under each drinker. The brick supporting each drinker should lie flat, with half above the bedding and half below it. Arrange the drinkers and feed trays in an alternating pattern so the chickens can reach water and feed with the shortest possible distance. Stocking density: 14~15 chickens per square meter.
3、Before the chickens arrive, also prepare boiled and cooled water, starter feed, antibiotics, electrolytes and vitamins, glucose, and other supplies. Put boiled and cooled water containing 3% glucose into the pens half an hour in advance so the chickens can drink as soon as they arrive.
II. After the Chicks Arrive
1、Unload the vehicle as soon as possible after the chicks arrive, working in an orderly manner to avoid mistakes in the rush. Place the chickens in the pens in the calculated quantities, then open the box lids. After unloading, carefully place the chicks into the pens as soon as possible. Set the individual cardboard boxes down in different locations so the chicks are evenly distributed, then remove the boxes from the chicken house.
2, if there is no feeding tray, cut the cardboard box used to hold the chicks to a height of 4 centimeters and use it as a feed tray.
3, Temperature: Observe the chicks to determine the temperature.
(1) The temperature is suitable, and the chicks are evenly distributed in spots around the heat source.
(2) The temperature is too high; the chicks move away from the heat source, pant with their beaks open, and drink more water. Their appetite decreases, so lower the temperature promptly.
(3)The temperature is too low. The chicks are huddling together around the center of the heat source and continuously chirping sharply; increase the temperature.
(4)The temperature is uneven, and the chicks are huddling around the heat source. Find out the cause promptly to avoid losses.
4, lighting. Arrange the bulbs at alternating heights; the brighter the better. Provide lighting for 1~3 days, 24 hours a day, then reduce the lighting by 1~2 hours each day until natural lighting is reached.
Three, providing drinking water and starting feeding
1, drinking water
(1) Whether chicks are raised in cages or on the floor, they should be given water as soon as possible after arrival. For caged chicks, it is best to use both water lines and drinkers at the same time, because chicks are curious about the nipples on the water lines and will keep pecking at them, making it easier for them to drink and improving survival rates. For free-range chicks, place the starter tray flat on the bedding. Hold a small amount of water in one hand and sprinkle it over the tray so that droplets form and reflect the light, attracting the chicks to drink.
(2) Whether chicks are raised in cages or on the floor, add only a little water at a time to the drinkers and refill them frequently. Clean the drinkers every day.
(3) During watering, observe the chicks carefully. Train any chicks that do not know how to drink by guiding them to drink manually until they can drink on their own. Do not give glucose water for too long; after 2–3 hours, it can be replaced with plain water.
2, starting to feed
(1) Chicks can be given feed 3 to 4 hours after they arrive and drink water. On the first day, it is best to moisten the feed with water before giving it to the chicks. This can promote digestion, prevent dehydration, and improve survival rates.
(2) For the first three days, feed for caged chickens can be placed in feed buckets or on paper; on the fourth day, switch to troughs. For the first three days, floor-raised chickens can be fed using starter trays or the paper boxes used to hold the chicks; on the fourth day, switch to small feed buckets.
(3) 12 hours after the chicks begin drinking water and eating, feel each chick’s crop one by one. Set aside in a spare cage (pen) any chicks that have not drunk water or eaten feed, and care for them individually so they can drink and eat.
Precautions
1 Many poultry farmers believe that the higher the temperature when chicks arrive, the better, as this helps yolk absorption. The temperature may even reach 37 to 38 degrees Celsius. They do not realize that this causes considerable harm to the chicks’ development. High temperatures reduce feed intake, affecting early growth and development; the chicks’ feathers become ruffled, and they grow slowly.
2 Poor ventilation is another issue. Many poultry farmers believe that ventilation is unnecessary during the first week because they are afraid the chicks will get cold. This leads to poor ventilation during brooding and poor air quality in the brooding room. It can damage the epithelial cells of the chicks’ respiratory tract, making them more susceptible to respiratory diseases.
3 On the fourth day, when turning off the lights, remove the feed one hour in advance so the chicks can drink enough water.
4, humidity should be closely monitored during the first week of brooding. If humidity falls below 50%, this can result in poor production performance and poor flock uniformity. Humidity should be increased immediately to prevent dehydration in the chicks.
5, because the temperature difference between the upper and lower tiers in cage-reared chickens is large, uniformity can be affected. Therefore, when beaks are trimmed at 5–7 days of age, separate the larger and smaller birds into different groups and swap the positions of the birds on the upper and lower tiers. This helps improve uniformity.
6, in winter, if chickens become chilled during transport, do not put them directly into the chicken house upon arrival. First place them in the workroom to recover. If they are put directly into the house, the sudden move from the low-temperature transport vehicle to the high-temperature brooding house will increase stress and mortality.
In short, if abnormal behavior occurs among the chicks during the first week or the mortality rate exceeds 1%, review the feeding and management practices, identify any problems, and resolve them promptly.