With the rapid development of large-scale broiler breeder farming in China, broiler breeder rearing techniques have gradually improved. However, attention is often focused on the laying period, while the rearing period is overlooked. This article briefly describes the feeding and management of breeder males during the rearing period.
Step one: Feeding management during the early rearing period (6–19 weeks)
1 Maintain uniformity and control body weight
This work focuses mainly on the period from 6 to 12 weeks. Although, after selection, the roosters’ uniformity is around 95% and their body weights are relatively close to the standard, controlling the roosters remains difficult and requires several measures: (1) Keep rooster density at around 4 birds/square meter; (2) Raising them in small pens (around 200 birds per pen) can ensure uniformity; (3) Weigh them weekly, sort them into separate pens again at 10 weeks of age, and trim the beaks of roosters with poor beak condition; (4) After selection, depending on the flock’s condition, restrict feed for 1 to 3 days to bring their weight down by 150 to 200 g, then resume feeding at a low feed level (around 65 g for 6 weeks) and switch to low-energy feed; (5) As with the hens, use a 4 to 3 feeding restriction until 16 weeks, allowing the breast muscles to gradually reduce and the front end of the keel to rise, while keeping body weight within the standard range and no more than 10% above standard body weight; (6) This is a critical period for the development of muscles, tendons, and ligaments. Keep the litter dry and do not install slatted floors too early, as this could damage the roosters’ joints.
2 Focus on weekly weight gain to ensure reproductive system development and the development of good body conformation
Weeks 13–20 are a critical period during which the reproductive system (especially the testes) begins to develop and body shape is fully formed. Weight gain should be assessed based on weekly weight gain rather than absolute body weight. Even if a bird is overweight, its weight must not be forcibly brought back to the standard, as this would cause permanent damage to testicular development. Only by keeping the rate of weight gain consistent with the standard can the rooster’s reproductive system develop without delay and body shape be formed without adverse effects.
(1) Reproductive system development
Research shows a strong correlation between the number of Sertoli cells and sperm production capacity. The potential for maximum sperm production capacity is established at 8 to 12 weeks of age. Damage caused before 12 weeks of age is irreversible. Later, measures such as feed formulation can improve the quality of the rooster’s sperm, but no measures taken later can increase sperm quantity. Therefore, starting from week 8, we should pay attention to feed, body weight control, feed quality, and the poultry house environment (especially avoiding high temperatures), and avoid stress that affects rooster growth and development. During weeks 13–20, continue increasing feed to stimulate rooster development and meet the needs for body weight gain and testicular development, ensuring that the testes respond to the first photostimulation. During this stage, the feed should ensure adequate crude protein intake for the roosters while limiting energy to prevent excessive weight gain. Testicular development can be assessed by observing the comb.
(2) Develop a well-formed body
At week 12, body size development is 90% complete. During weeks 13–20, the main focus is shaping the body. Adjust the feeder pans and water lines continuously according to the condition of the flock, so that the roosters have to exert slight effort when eating and drinking at the feeder and water lines. This helps exercise the chickens’ shins and leg muscles, positions the breastbone at an angle of 45 degrees to the ground, and prevents a hunched back, facilitating mounting and mating later on.
Two Management during the later rearing period (20–25 weeks of age)
After 20 weeks of development, the roosters are basically ready in all respects. The rearing period is about to transition into the laying period. The main tasks at this stage are inspection, increasing light, mixing flocks, and separating males and females for feeding.
1 Inspect the management results during the rearing period and make final adjustments
At this stage, assessing the roosters’ uniformity and development cannot focus on body weight alone; their body condition, more specifically, breast shape, must also be checked. Score the breast muscles to assess the roosters’ development and uniformity, and determine the feeding plan for the next stage. Check breast shape at least once a week during weeks 20 to 25. At this stage, the ideal breast-shape score is between 2 and 3, and the feed quantity at the end of week 25 is about 120 g.
2 Mixed-sex group housing
Mixed-sex group housing is generally carried out between 20 and 23 weeks. If it is done too early, separately feeding males and females is more difficult; if it is done too late, it is less conducive to feeding males and females separately and to harmonious coexistence between male and female chickens.
(1) Before mixing the flocks, conduct a final selection of the roosters. Select breeding roosters with pronounced secondary sexual characteristics, normal body condition, neatly trimmed beaks, strong legs and toes, bright plumage, an upright stance, and well-developed muscles. Place birds of similar size in the same pen whenever possible. Rest unsuitable roosters (for example, by trimming their beaks) or cull them.
(2) The rooster-to-hen ratio when mixing flocks is generally between 8% and 10%. The specific approach varies depending on when the flocks are mixed and the sexual maturity of the roosters and hens. If mixing takes place before 20 weeks, a sufficient number of roosters (8%–10%) can be added at once. After increasing the lighting, take measures based on how closely matched the roosters’ and hens’ sexual maturity is and how well they get along. If the roosters are overly aggressive, remove 1%–3% of them as appropriate, then gradually add enough to reach the target once the hens have adapted. At 22 weeks of age, first mix in mature roosters at 5%; at 23 weeks of age, add another 2%; and at 24 weeks of age, add the remaining 2–3% of the breeding roosters. Alternatively, at 22 weeks of age, mix in 9%–10% of the roosters at once. At 30 weeks of age, remove roosters that are poorly developed, have a lighter-colored vent, mate infrequently, or are especially heavy or light (about 2%), and promptly cull or replace them.
3 Separate feeding for males and females
After the groups are mixed, the most important task is training the birds to feed separately by sex. This training must continue for at least 4 weeks. The better the training, the more effectively males and females can be fed separately during the laying period, the easier it is to control body weight, and the more stable and consistent the fertility rate will be.
(1) Roosters do not eat feed intended for hens
To limit roosters’ access to feed intended for hens, make use of their large combs and broad heads. For example, the width of the hen-feeder opening on a chain feeding line with an anti-roosting grid is 45 mm, and its height is 65 mn (controlled by installing a PVC pipe or attaching a sealing strip). Roosters cannot reach their heads into the feeding line to eat the hens’ feed. If the flocks are mixed too early, a nose stick can be fitted to the roosters. With a pan feeding line, adjusting the inner grille setting to control the width and height makes it easier to feed roosters and hens separately.
(2)Hens do not eat rooster feed
To limit hens from stealing rooster feed, make use of the fact that roosters are taller than hens. Set the height of the rooster feed line according to the roosters’ height when the flocks are mixed; adjust it to the specific circumstances.
(3)Separate feeding training for males and females
In the weeks before mixing males and females, try to use the feeders that will be used after mixing. Prevent males from using the feeders for females and females from using the feeders for males.
equipment; in the early training period after mixing the groups, ensure there are enough staff. During feeding, ensure there is someone in each pen (determine the number of staff according to the number of chickens; at least 500 people are needed for 1 chickens). After lowering the rooster feed line, promptly move any roosters on the hen feed line to the rooster feed line, and any hens on the rooster feed line to the hen feed line. If conditions allow, hang a net between the rooster and hen feed lines, and remove it after feeding.
4 Supplemental lighting
Supplementary lighting is generally carried out for both male and female chickens between 21 and 23 weeks. To ensure that the timing of supplementary lighting is correct, the specific lighting plan must be formulated after a comprehensive assessment of
the development of both male and female chickens. After supplementary lighting, their secondary sexual characteristics develop rapidly. Adjustments must be made promptly according to on-site conditions to ensure that both male and female chickens develop well and coexist harmoniously.
(1) Difference in body weight between males and females
Excessive body weight in roosters can intensify fighting among roosters and increase mortality and culling. It can also make hens afraid of roosters, reducing mating frequency and success rates. Excessive body weight in hens can make roosters afraid of hens, causing “social castration,” and can also intensify fighting among roosters, increasing mortality and culling. There must be an appropriate weight difference between males and females, with roosters weighing slightly more than hens. At 20 weeks, the maximum difference in body weight between males and females may be 680 g. At 25 weeks, roosters weigh about 20% more than hens. Throughout the laying period, the difference in body weight between males and females should be 15%–20%. If the difference exceeds 40%, the fertilization rate will be seriously affected.
(2)Body condition and development determine the exact timing for increasing light exposure.
Before adding light, both roosters and hens must be scored. For roosters, primarily assess molting, breast muscle, body weight, and comb; for hens, primarily assess fat accumulation, pubic bone spacing, molting, body weight, and comb. Lighting may be added only after 80% are ready.
Rooster testicular development after adding light (3)
The period from 2 to 3 weeks after the lights come on is when the testes develop rapidly. Feed intake must increase every week (by at least 1 g) to maintain rapid growth in the roosters. Excessive feed restriction during weeks 18 to 23 can seriously affect sperm production. As the testes develop rapidly, the roosters’ combs and wattles also grow rapidly and become redder. Research indicates that comb size is positively correlated with testis size.
(4)Add light rooster management
As secondary sexual characteristics develop rapidly, males and females gradually reach sexual maturity. If they do not mature at the same time, this can significantly affect the fertilization rate, so timely measures need to be taken to correct the disparity as early as possible.
The roosters are developing too quickly, and the hens are avoiding them. There are fewer hens on the floor, and the roosters are aggressively chasing the hens. Some hens are forcibly mated before they are mature and become afraid of roosters for the rest of their lives. Hen culling due to mortality also increases substantially as a result of mating-related injuries. In this situation, the proportion of roosters can be reduced appropriately (7%–8%). At the same time, staff can walk on the floor to encourage the hens to leave the slatted floor (movements must be gentle and must not cause the hens to fly into a panic or stampede). If there is a water line in the litter area, the middle water line can be activated to attract the hens off the slatted floor. Once many hens have moved off the slatted floor and the roosters are chasing them less, gradually adjust the proportion of roosters back up and gradually discontinue measures such as driving the roosters away.
The hens are developing too quickly, and the roosters have not mated with them in time. This situation is uncommon. If it occurs, immediately check factors such as the roosters’ water, feed, temperature, lighting, and separate feeding of hens and roosters (including whether the hens are eating the roosters’ feed). After eliminating unfavorable factors, the amount of feed for the roosters should also be increased appropriately to promote their rapid development.
The key to managing roosters during the rearing period is to adopt different feeding and management measures according to their stage of development, ensuring that their nutritional needs are met while keeping their body weight and conformation within target ranges. Weight control is crucial to raising breeding roosters, and its success is closely linked to the effectiveness of feeding males and females separately. Only by giving due attention to nutrition and management can breeding roosters fully realize their genetic potential and improve their viability and breeding value during their use as breeders.