A pig house is essentially an artificial environmental system. The dividing line between traditional and modern pig houses is not their appearance, but whether the temperature, humidity, ammonia concentration, and ventilation rate inside can be measured and adjusted. Pigs cannot speak, but environmental parameters signal changes before production results do.

  The pig house building itself is the first layer of the environmental control system. The span is typically 9 to 15 meters, the length 40 to 80 meters, and the eaves height 2.5 to 3.5 meters, depending on the degree of enclosure. The roof should use double-layer color steel sandwich panels (polyurethane or rock wool) for thermal insulation. The concrete floor should slope 1% to 2% toward the manure channel to provide drainage and prevent slipping. These dimensions are not aesthetic choices: they directly determine whether subsequent ventilation airflow can be distributed evenly, whether manure can be removed smoothly, and the cooling load in summer and heating load in winter. Pigs at different physiological stages have very different space requirements: individual stalls in breeding and gestation houses are 2.1 to 2.2 meters long and 0.65 to 0.7 meters wide; the area per pig in finishing houses is 1.0 to 1.2 square meters; and farrowing crates are 2.2 to 2.4 meters long and 1.8 meters wide. Insufficient space is itself a persistent environmental stressor.

  What makes “controllable” a reality is the coordination of ventilation, temperature, and humidity. The primary goal of ventilation is not the number of air changes, but keeping ammonia, hydrogen sulfide, dust, and water vapor within levels the herd can tolerate. As general industry reference indicators, ammonia concentration is usually kept below 20 mg/m³, hydrogen sulfide below 8 to 10 mg/m³, and relative humidity is preferably 60% to 70%, with a maximum of 80%. The requirements for farrowing and nursery houses are stricter; the ammonia limit can be as low as 12 mg/m³. The ventilation system design needs to match the pig house area: practical experience suggests that providing 1.5 kW fans for every 100 square meters, with an inlet-to-outlet area ratio of 3:1 and indoor air speed kept within 0.3 m/s, is a practical reference framework.

  The challenge of temperature control lies in the differing needs within the herd. Suckling piglets need a heated creep area at 30 to 32℃, while finishing pigs are sensitive to heat. Within the same building, “zoned precision temperature control” is more appropriate than maintaining a uniform temperature throughout. In summer, use evaporative cooling pads together with tunnel ventilation; in winter, maintain the temperature under minimum ventilation. Configure underfloor heating, hot-air heaters, and heat lamps by zone. A more advanced approach is to let algorithms manage environmental control: studies have shown that improved control strategies can keep indoor temperature fluctuations within ±1.7℃, stabilize ammonia below 25 mg/m³, maintain relative humidity at 58% to 62%, and complete multi-parameter adjustments in about 18 minutes. This means environmental management is shifting from “people turning fans on and off by feel” to “systems automatically optimizing based on parameters.”

  Small and medium-sized pig farms do not need to pursue full automation all at once. They can first ensure adequate heating and ventilation in farrowing and nursery houses. Finishing houses can use a semi-open structure together with axial fans and roof ventilation ducts to achieve basic parameter control. The return on investment in environmental control is not reflected in any single piece of equipment, but in long-term changes in feed conversion ratio, disease incidence, and medication costs.