The core challenge in autumn and winter pig barn management has never been whether to ventilate, but how to keep temperatures stable without letting ammonia and moisture weaken the pigs’ respiratory defenses. Many pig farms seal the windows to retain heat as soon as temperatures drop, then throw them open for a while when the ammonia smell becomes pungent. These repeated swings between cold and warm can lead to even more coughing, wheezing, and diarrhea among the pigs than in summer.

 

The root of the problem lies in the ventilation method itself: crude “wide open, fully closed” ventilation essentially trades air quality for temperature, then offsets the temperature advantage gained with cold stress. The real direction for improvement is to shift insulation from “sealing everything in” to “protecting specific areas,” and ventilation from “opening and closing windows” to “low-volume, continuous, controlled microenvironment regulation.”

 

 

I. First, understand this: What really harms pigs in autumn and winter is often not the cold, but drafts.

 

The temperatures shown on thermometers in many pig barns meet the target, yet the pigs are still coughing and huddling together. The cause is often drafts. Cold air seeps in through the bottoms of roll-up curtains, holes in walls, feed-line entrances and exits, and gaps in drainage channels, then flows along the floor into the lying area. Thermometers do not detect it, but pigs lying on the ground are continuously chilled around the chest and abdomen; the perceived temperature can be 3—5℃ lower than the actual barn temperature.

 

Dry coughing caused by cold stress from drafts and “coughing and wheezing from stuffiness” are easily confused: the former occurs when cold drafts damage the respiratory mucosa, allowing Mycoplasma to take hold; the latter occurs when people, concerned about the cold, close the windows and turn down the fans, so ammonia and dust cannot escape and continue irritating the respiratory tract. The two situations call for completely opposite responses—block drafts, but ventilate when it is stuffy. In practice, however, many people mistake “coughing and wheezing from stuffiness” for “having caught a chill” and keep the windows closed, making things worse the more they cover the animals up.

 

The first step in improving the pig house is not to rush into installing equipment, but to conduct a “gap inspection” after autumn begins: place sandbags along the bottom of the roll-up curtains, seal gaps at corners with weatherstripping or foam sealant, and install deflectors at air inlets so cold air flows upward, mixes with the warm air above, and then descends, avoiding direct drafts on the pigs. During nighttime rounds, do not rush to turn on the lights; observe the pigs in the dark. Huddling in piles indicates cold air is getting in, while lying apart but snorting and sneezing indicates excessive ammonia and dust.

 

 

Two. Improvements to insulation: shifting from “whole-house insulation” to “targeted local temperature protection”

 

The most common mistake in autumn and winter insulation is trying to keep the entire pig house at a temperature suitable for all pigs. But pigs at different stages have vastly different temperature requirements, especially when sows and piglets are housed together—a conflict that is almost impossible to resolve.

 

The direction for improvement is “a stable macro environment, precise micro environments”:

 

Farrowing room: The suitable temperature for sows is 18—20℃, but newborn piglets need 32—35℃. Do not try to heat the entire farrowing room above 30℃ to accommodate the piglets. Instead, set up a creep area outside the sow’s lying area, with an infrared heat lamp and an electric heating pad, to create a localized “microclimate” for the piglets. Temperature management in the piglets’ lying area can be adjusted by age in days: maintain 32—30℃ at 1—2 days of age; starting at 3 days of age, lower the temperature by 0.3—0.5℃ each day; and maintain 26—24℃ at 3—4 weeks of age.

 

Nursery: For newly weaned piglets, maintain 26–28℃ initially, then lower the temperature by 1–2℃ each week. Underfloor heating combined with heat lamps is a relatively reliable setup. Chilling of the abdomen during the nursery stage is an important trigger for diarrhea; keeping the floor warm is more direct and effective than heating the air.

 

Fattening house: The temperature should not be below 16°C to ensure feed conversion efficiency. The greater the body weight of fattening pigs, the stronger their ability to generate heat. Excessive insulation may instead make the house stuffy and hot, reducing feed intake.

 

For pig houses with poor wall insulation, adding insulation curtains, double layers of plastic sheeting, or foam boards is not costly, but it does effectively reduce heat loss at night. In floor-raised pig houses, adding more dry bedding is itself an economical and effective “natural insulation layer.” The bedding insulates against the cold floor and also generates some heat through fermentation.

 

 

Three. Improving ventilation: replace “large-scale air exchange” with “continuous small amounts”

 

The key to improving ventilation in autumn and winter is not to increase the frequency of ventilation, but to change how ventilation is organized. The goal is to keep ammonia, moisture, and dust in the barn within threshold limits while introducing as little cold air as possible, without causing drastic fluctuations in the pigs’ perceived temperature.

 

First, switch from “longitudinal ventilation” to “cross ventilation.” Longitudinal ventilation, commonly used in summer, draws air in at one end and uses fans at the other end to exhaust it. It provides high air speed and good cooling, but in autumn and winter, cold air blows directly over the pigs over a long distance, creating a high risk of cold stress. In autumn and winter, switch to cross ventilation: let air enter through inlets in the side walls or roof, flow slowly across the barn, and then exit, preventing cold air from blowing directly into the lying area.

 

Second, use variable-frequency fans for “continuous, low-volume ventilation.” In winter, there is no need—and it is not advisable—to exchange a large volume of air all at once. Variable-frequency fans can run continuously at low speeds, maintaining air exchange with a very small airflow. This keeps ammonia concentrations low without causing a sharp drop in house temperature. At night, maintain the minimum ventilation rate, then moderately increase the fan speed during the warmer parts of the day.

 

Third, take advantage of the “midday high-temperature window” for concentrated air exchange. Even with continuous low-level ventilation, it is still advisable to open the vents on the leeward side or briefly increase the fan speed for a few minutes during the midday period when the temperature is relatively high. This rapidly replaces the stale air that has accumulated overnight. Then promptly restore the heat-retaining conditions. This “short-term, high-efficiency air exchange” has a more controllable effect on temperature and higher ventilation efficiency than leaving a small gap open all day to let air leak in slowly.

 

Fourth, the direction of the air inlet is more important than the size of the opening. Cold air blowing directly onto pigs can cause localized cold stress, even when the airflow is very low. Give priority to roof air inlets or side-wall air inlets with deflectors, so that cold air first flows toward the upper part of the building, mixes with warm air, and then gradually sinks. This prevents a “cold draft” from blowing directly onto the pigs’ backs.

 

 

Four. Coordinating insulation and ventilation: make decisions based on “ammonia,” not “feelings”

 

The biggest practical challenge with ventilation in autumn and winter is deciding how much to open it and for how long; relying on intuition can easily lead to either extreme. The key to improvement is to shift the basis for decisions from “whether people feel cold” to “whether the air the pigs breathe meets the required standards.”

 

The new version of the Technical Specification for Environmental Parameters and Environmental Management of Large-Scale Pig Farms (GB/T17824.3—2026) has explicitly tightened the ammonia limits: the upper limit is 15 mg/m³ for growing-finishing pig houses, empty and pregnant sow houses, and boar houses, and 12 mg/m³ for farrowing sow houses and nursery piglet houses. The hydrogen sulfide limit has also been tightened substantially. This means that “it smells a little, but it’s still bearable” is no longer an acceptable standard.

 

In on-site operations, ammonia concentration is a more sensitive ventilation indicator than temperature. After entering the barn, if people experience slight eye irritation or a tingling sensation in the nose, it is generally possible to determine that ammonia levels are approaching or exceeding the threshold at which ventilation should be increased. Pig farms with the means to do so should be equipped with portable ammonia detectors or fixed sensors, turning the decision of “when to increase ventilation” from an experience-based judgment into a data-based one. Keep relative humidity at 60%—70%. When it exceeds 75%, ventilation must be increased to remove moisture; otherwise, dampness will aggravate both respiratory and skin problems.

 

Another easily overlooked detail is nighttime management. Pig activity and heat production decrease at night, but ammonia continues to be produced. The right approach is to maintain a minimum level of continuous ventilation at night, rather than shutting the fans off completely and sealing all doors and windows. Once temperatures rise again during the day, increase the air exchange rate appropriately, following a “minimum ventilation at night, increased ventilation during the day” rhythm.

 

 

Summary

 

Improvements to insulation and ventilation in pig housing during autumn and winter can be summed up in three points: insulation shifts from “sealing up the entire barn” to “protecting local areas”; ventilation shifts from “wide open or fully closed” to “continuous, minimal airflow”; and decision-making shifts from “going by feel” to “monitoring ammonia levels.”

 

First, seal gaps where drafts can enter and establish a sound local microenvironment for the piglets. Next, switch to a combination of horizontal ventilation, variable-frequency control, and concentrated air exchange at midday. Finally, use ammonia concentration and humidity as the sole criteria for adjusting ventilation. Once these three steps are in place, insulation and ventilation are no longer a difficult “either-or” choice, but two goals that can be addressed simultaneously within the same system. (Source: 张伟光)